1. When the vibrating screen is usually installed on the ground with a flat and level cement base, it can be fastened without anchor bolts; if the ground of the base is not flat, the rubber feet under the equipment can be adjusted appropriately to achieve the three-dimensional vibrating screen. The whole is stable;
2. If the vibrating screen is installed on the pedestal of the steel structure due to the needs of the site, it must be fixed with bolts, and the steel structure must have sufficient rigidity to support the vibrating screen to avoid safety during the use of the equipment. accident;
3. The vibrating screen needs a three-phase switch, the wire is connected to the power supply, and the electrical control panel must be installed on the wall to avoid unsafe factors;
4. Before the equipment is connected to the electrical control panel, it must be checked whether the electrical control panel is normal;
5. When the three-dimensional vibrating screen is powered on and running, it is necessary to carefully observe whether the vibration motor is working properly. If there is any abnormality, adjust it to ensure normal discharge. The inspection of the vibration motor includes the following two items: ①. Determine whether there is any abnormal noise ② .Whether the motor is reversed (counterclockwise rotation of the anti-line is reversed).
6. The excitation force of the vibration motor can be adjusted by adjusting the counterweights and their phase angles of the eccentric blocks at the upper and lower ends of the motor, and can be adjusted reasonably according to the different screening requirements of the materials to be screened;
7. The screen of the three-dimensional vibrating screen has been installed according to the customer’s needs before leaving the factory. The screen is a wearing part. During the use of the equipment, the screen should be regularly checked for damage and replaced in time according to the situation.